Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have a CSS 11503 LB that I am using to balance 443 and 80 traffic and I have it working but my question is if a users are coming from a proxy should I continue to use Layer 3 LB technique? Also is it possible to see the real IP address i...
I have an ASA 5540 and I have ACL's applied to inside and outside int's that allow all traffic currently and I have proved that the ICMP and SSH traffic is being allowed by doing a packet trace. I did notice in my logs that when an ICMP packet hits ...
I have a ASA 5540 and currently two route statements one for the inside traffic and the other a DF route to the outside. The ACl I have is an extended ACL allowing IP to any any applied to the in interface inside, out interface inside. Yet I can no...
I have a pix 525 and every other month it hangs up of which I lose connectivity and I have to reboot. Once rebooted everything works and I am trying to see if anyone else is having this problem. I checked the processor and logs and I see nothing.
Ok that is what I was thinking but just wanted to make sure but the next question is why am I having problems connecting to the inside interface via SSH? The PIX allows this and the ASA currently is not allowing me to do this.
I have an access-list that allows echo and echo reply but I can not ping thru the device. When logged into the console I can ping everywhere. I have an access-list on the Inside interface for in and out bound traffic that permits IP any any to incu...
