Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 515 and use the Cisco client to allow remote connections for employees. How do I disconnect a single session?I know that clear uauth doesn't do it. And I've seen some talk about clear ipsec and clear isakmp sa peer and such, but I can'...
I have a question as to whether the following scenario is possible to configured.I have a main site, that needs to create a VPN tunnel to remote client sites, assumably via a LAN-2-LAN connection. I need to be able to access all routable subnets on ...
I tried that command and it does not work.I am running PIX Firewall Version 6.3(3).I don't have an option of clear crypto from the # prmopt, and in config mode, I don't have a clear crypto session command.Any other ideas?
Thanks fo much for replying. That work fine, but I have an additional layer of complexity, I think.I have multiple non-consecutive nets on the client end that I need to be able to NAT. I haven't seen how I can apply additional subnets, or even just...
