Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Pix 501 that is connected on the e0 interface to a Cisco 2950 switch. Been having some problems getting out with it from the internal network and when I do a show interface command on e0 it shows interface is up, line protocol is down. I'v...
sh run comes back with interface ethernet0 10baset.sh interface eth0 comes back withMTU 1500 bytes, BW 10000 Kbit half duplex.How do I check the port speed on the 2950?
