Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a pix501 and want to configure a routing for bloomberg router. But the pix501 does not have enough interface for the configuration. we don't have spare router or layer3 switch. Any suggests?thanks.
Hello,I followed technical note (http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806de37e.shtml) to configure remote Radius authentication, but got following error message when try to verify the Radius from...
for a private connection to bloomberg, all hosts must be able to connect to the following bloomberg subnets:208.134.161.0/24205.183.246.0/24...etc.how can pix501 configure to route statically to the above prefixes through the ethernet port of the blo...
i can ping that radius server from ASA, how can I verify the posts from radius?i can sure that the shared secret key is same as the key in aaa- server firewall.
