Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to setup a Cisco 1841 VPN tunnel for a Netgear FVS14 at a remote location. I have tried the SDM and everytime I submit the rules, the 1841 locks up and reboots. I can create a site to site VPN with dymanic IP (remote) correct?
Gilbert,I figured out that I was using the "step by step" wizard and used FastEthernet0/0 option and I think that is what was causing the lockup. I tried using the FastEthernet 0/1.217 and it configured but then I could not get outside the firewall....
