Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am new to CISCO appliances and while configuring my ASA 5505 I changed the IP address range of the internal network. Obviously I made an error because I cannot reach the box neither at the old nor the new address. How can I restore the interfac...
Hmmm. After a reboot, ther problem is back again. I did a "write memory". Can it be I have to select a certain image ? Perhaps I already chonged something unwillingly; I tried to follow the password recovery strategy explained in I did something like...
Well, that exactly shows the problem : I already looked at this doc before, but the index does not contain reset, factory, default or similar words; I read through several paragraphs of it and did not find a hint. This is why I asked in the first pla...
Thanks a lot. I will try asap; at the moment I am not near the router. Where could one find these commands in the docs ? I tried to look at the 2800 page command reference but afterwards I had lsee clue than before....
