Now I can reach the firewall from internal network. But still don't get internet access nor can I see dmz.CiscoASA# show routeS 0.0.0.0 0.0.0.0 [1/0] via xx.xx.xxy.1, outsideC 10.16.0.0 255.255.252.0 is directly connected, outsideC 10.16.52....
Hi!I tried to configure the ASA 5510 yesterday with the ASA Quick Start Guide but failed totally so I wanted to get a clean reset. I tried to reset it but something went wrong. Can't remember what it was but now when I try to connect to ASDM I get th...
I wasn't thinking about the management0 interface. There are 4 interface ports on the firewall but I can only use 3 of them with my current license.I need Internal, External, DMZ and one more.
The old firewall is a Pentium MMX computer with some Clavister firewall software I think.I couldn't ping the gateway.-------------------------------------------Result of the command: "ping xx.xx.xxy.1"Sending 5, 100-byte ICMP Echos to xx.xx.xxy.1, ti...
I don't know how to ping stuff from the ASA.My gateway that I received from ISP is xx.xx.xxy.1 and I can ping it with the old firewall. The firewall is connected to the wall and that leads us to the city network.Gateway for the computers in the netwo...
Now I could access dmz but it was very slow. Couldn't ping it either and no internet access.---Result of the command: "sh int e0/0"Interface Ethernet0/0 "outside", is up, line protocol is up Hardware is i82546GB rev03, BW 100 Mbps Full-Duplex(Full-d...
I reset everything to factory default after learning some more about what the different settings do. The result is same though I'm afraid. I can't access internet nor dmz.----------------------------------------inside = 10.16.54.0 255.255.255.0firewa...
