Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having a problem getting web access from my dmz network. It has a higher security-level than the outside interface, so shouldn't I be able to get outside internet access from the dmz? Inbound access from outside to the DMZ works fine the way I ha...
I've got a 5510 and I'm having a problem trying to get internet access from my development boxes and was hoping someone could take a look at what I have wrong here.I'm trying to forward www, https, and 3690 from the outside - PAT to my dmz, ssh to my...
I'm trying to get www, https, svn(3690), and ssh from one of my inside networks to get outside access, but this isn't working for me yet. Can anyone provide some insight as to what I've got wrong on my 5510 configuration? I'm sure it's probably my st...
I have an ASA5510 w/ v7.0(7). I'm trying to see why none of my machines can get on the network so I'm working the troubleshooting section and trying to ping the interface.I entered:hostname(config)# debug icmp tracedebug icmp trace enabled at level 1...
I'm trying to do some basics right now by just getting ssh going between the different interfaces and I can't seem to get any of them talking, meaning, one host on one network to another. And once I get them talking on the inside, I wanted to be able...
I thought it was allowing only 3 of the 4 services I care about to get into the DMZ and ssh to the others. However, it did work.I guess it has something to do w/ PAT which I don't quite understand yet. Do access-lists override PAT, was I using them b...
I guess I'm not following here. I want to have the traffic of ALL_SERVICES accessable from the outside as well as use them from the inside, so that's why I put it on both interfaces in both directions.I made a small change so the following is what I'...
I havent' been able to progress any further beyond this point (pinging the interfaces), but did receive the following from someone about ssh (which is what I'm trying to do). Is this correct?---"The ASA/PIX intercepts the SSH request. The only way I ...
I'm configuring the 5510 through the serial console and trying to do the ping from within the 192.168.3.0 network and not from the management interface, Here it is ...5510(config)# show run: Saved:ASA Version 7.0(7) !hostname 5510enable password <>.....
