Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
We are not able to access the firepower chassis manager GUI. Though we can ping and ssh the firepower management IP address but not able to access the firepower chassis manager.
any help on the same would be highly appreciated. badly stuc...
Hi All,
I am not able to exit out of the firepower module back into FXOS from Cli. I tried exit command also tried ~ as well. but it does not accept the command.
We have changed the management ip of the chassis and we are able to access it via SSH ...
Hi,
We have the FTD and FMC connected over the management ethernet interface. We have licensed the device via FMC. This is a 2120 FTD appliance. We are trying to setup SSH for the FTD appliance for troubleshooting purposes. We are following the pro...
Hi,
Has anyone tried integrating Okta or any other two-factor authentication with captive portal on FTD. Couldn't find any configuration example on the same. Any help would be great.
Vaibhav
Hi,
Just setting up a new 2100 but unlike the 4100 the default management address opens up the FDM and not the Chassis manager.
even though I have data interfaces connected and enabled the interface on the GUI it's still in amber color in the GUI...
Hi Evan,
I had been trying to get this information but I have got mixed responses. some said there is no per day limit for the firepower devices and it's only for the endpoints. I am not sure where did you get the no. of 200 files per day. There is...
Hi marvin
Thanks again. Like I had mentioned earlier since we are moving the firewall to a new network we wanted to change the firewall network settings. Hence before we changed the IP address the FTD physical interface which is mapped to the logic...
Hi Marvin,
Thanks a lot for your prompt response. I had initially logged into the device using the same IP address by which I was able to access the Chassis manager GUI.
I SSHed into the firewall on the same IP address. then using the configure n...
