Having a pix 506 and its look like has some but could not figure out .Every time when we out sh arp command then its reboot with out any output results.Running on following Ver 6.3 (5)

Hi, IPSec tunnel is running between 2 sites.Now we need to configure static NAT for 1 IP address comes under overlapping subnet.When we configure static nat then whole traffic is transfered to the static nat connection and my tunnel see not traffic....

Hi,On our two sites, we are using PIX 515E and from these sites, one having remote access VPN server.We have no problem to connect remote vpn from public network,but could not connect from other site which is behind the PIX.there is only PAT is happe...

Hi,Because same subnet are being in use between two sites local network. we have configured NAT overlap on IPSec VPN tunnel using ASA 7.0 and its working fine.But now on site where overlap NAT has been configured, users can not access internet.if we ...

Hi,we are using site to site vpn between three sites/offices using ASA 5510.Now for outside connection, we have configured remote vpn and its working fine with the local site where its connecting/terminated but could not able to ping/connect other 2...