Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't know if anyone else has noticed this but, I upgraded our PIX to 6.2 yesterday and the syntax of the Conduit command seems to have changed slightly. My Conduits from the previous OS were not taken and I had to recreate them all changing the sy...
I noticed that the conduit command doesn't seem to accept any global mask except for a /32 or the keyword host.It gives a "Source address doesn't pair" error.The only solution I could find was to use /32 or the keyword host.
I think the problem is that because the PAT can cope with many IP addresses you haven't reached the limit yet.What you could try is having a Global (outside) 1 and a Global (outside) 2 with different addresses, then have a NAT 1 and a NAT 2 on the in...
This sounds to me like you have an error with either your static or your conduit / access list. If you post the config (minus passwords) I will take a look for you. Routing shouldn't be the issue as you should have a default route pointing out from y...
