Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I have a very basic issue with adding a sub interface. Iam new to this setup so maybe Iam missing something. Our Cisco 5512 appliance has a few subinterfaces e.g
Interface GigabitEthernet0/1.1011 , is up, line protocol is up
MA...
Thanks. the error comes when i typeinterface GigabitEthernet0/1.1016 ^ERROR: % Invalid input detected at '^' markerThe ^ points right under the sub interface numberIf I try an existing interface it ...
