Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please help.Hi I'm new to this site. I need to open ports 5000 and 5001 on my Cisco PIX 501 to enable some users to be able to connect to our CCTV from outside, can anyone please advice how should I open these 2 ports?any help is very appreciated.Tks
Please help.Hi I'm new to this site. I need to open ports 5000 and 5001 on my Cisco PIX 501 to enable some users to be able to connect to our CCTV from outside, can anyone please advice how should I open these 2 ports? any help is very appreciated.Tk...
Hello ChiragMany thanks for your reply. I am not sure if I can manage this setup. does it need to be done through command prompt or it can be done through the PIX interface?Sorry not familiar with PIX.Tks,Ray