Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a client that purchased an ASA5505 at Cisco's recommendation to replace a PIX506e and I need to configure the site-to-site VPN that was in place originally. I'd like to do this without having to change anything on the remote site's PIX....
Thank, Paul! Everything looked like you said it should, but I'm going to change gears, here.I went back through the config for the remote PIX and found that it's on DHCP. I called the remote office and got their current IP and now the tunnel is up ...
Here is what is on the PIX at yyy.yyy.yyy.84. I changed the more sensitive info:sysopt connection permit-ipsecno sysopt route dnatcrypto ipsec transform-set strong esp-3des esp-md5-hmaccrypto map newmap 10 ipsec-isakmpcrypto map newmap 10 match addr...
Thanks for the answer, Paul. I used the IPSEC wizard for a site-to-site connection, but it didn't work, so more than likely, there's one little thing that is gumming up the works. Good to know I shouldn't have to change anything on the remote end, ...
