i have a CISCO ASA 5520, trying to lock down the tunnels to one direction using an ACL. It doesnt seem to work. Is this the preferred way to limit traffic?ASA 5520ASDM: 6.3(4)53ASA 8.2(3)
Ever since i have setup 2 ASA 5520's in a failover state. i cannot telnet or ssh to either device. if i reboot them it starts to work again, but not for long. does anyone know why this is occuring?
Thank you that works. could you explain or point me in a direction that explains the risks above. How could the remote network access the local network with these ACL's in place?
trying to rdp to a windows server on the remote network. If i trace a packet going this way it suceeds but i cant pass traffic such as a RDP session. I have a very long config that i would have to mask, is there a certain section that would assist?
Thanks, since i have 6 tunnels and doing different things on each. i like your first option. So i change the IP's to match what i need:access-list tunnel_lockdown permit tcp 192.168.20.0 255.255.255.0 range 1 1023 192.168.10.0 255.255.255.0 Now all ...
OK i dont understand the diffeence here, so heres what i want to do:i have a local network: 192.168.10.0/24remote network: 192.168.20.0/24i want 192.168.10.0/24 to access the entire network of the remote site( 192.168.20.0/24). But i dont want the re...
