Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm not a cisco expert so I hope to find one here! And I'm running ASA 8.0(4) on a 5510 using two ethernet ports where one is incoming and the other is used for outgoing traffic. My problem is really simple; I would like to block the AnyConnect po...
Hi Paul!> First you mentioned you needed to allow access from outside to inside and now you said that it is from outside to the WAN port.Sorry for the confusion and mixing up these terms, It's all new to me.. For me this is the same thing, but now I ...
>If it is from outside to inside i can assume you have at least a static nat translating a public ip to a private ip, right?I enabled AnyConnect VPN client access on the WAN port, so I had no static nat.Are you telling me I should enable the AnyConne...
Hi Paul, I want to block port 443 from outside to inside. In other words; I would like some IPs to have access but by default I would like to deny access. I hope you have an answer..
