Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if I am running ASA 8.3 (which runs as NAT0 by default - NAT is turned off) with REAL IP addresses if I have to still configure an OBJECT with NAT to allow traffic from a lower level interface (OUTSIDE) to a higher level Interface (I...
Does anyone have a good link that I can go to configure AAA TACACS on the ASA? I would like to know how to configure AAA on the ASA to go to the ENABLE MODE after authenticating to the TACACS server. Right now, when I log in, it takes me to the use...
Besides setting up a shared DMZ or something like this, is there away to setup a STATIC routes between contexts on the ASA running multiple contexts, or does the traffic have to go to a router to route among contexts?
Please let me know if it's possible to route among contexts (I have 5 contexts) in the ASA without sending traffic to a fusion router (external router) to be routed. I am running ASA 8.3.
Besides setting up a shared DMZ for all the contexts to access (which is the only documentation I have seen), is there any way to setup static routes between contexts on the ASA 55XX running IOS 8.3. Or does the inter-context traffic have to go an e...
Is it best to setup the AIP SSM using the IME or just from command line? Also, where can I get info on how to use the IME to provision the AIP SSM on the ASA?
