Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,who can help me to understand how work sla monitor IpIcmpEcho parameters?I have a problem with a Dual ISP configuration: the main one is connected to a DSL router while the backup router is an ISDN one.I configured sla monitor in the way of cisco ...
Hi, I have a problem with an ASA5510 configuration: I opened access from outside to inside to a mail server and a service to an AS400. But static NAT doesn't work correctly: if I try from internet I can't, but if I try from a source address in the sa...
Hi Manish,thanks a lot for your quick clear answer.Can you tell me which is the difference from timeout parameter (the general one) and particular service timeout parameter?thank youfrancesco
I checked configuration again and I found a new thing: if I remove configuration about tracking dual ISP all works correctly. Is it possible that "show route" says a route but this doesn't works?
But from inside I can browse the net. If the problem is arp cache, I can't browse internet too. From the inside I can go out and from the outside I can use inside services only from addresses of outside IP network.Thank you a lot.
Thanks a lot for the quick answer. I'm sure that this is not a routing problem because I have to substitute a pix506 with similar configuration and the routing is good for 506 and not for ASA. I check the ASA routing table and i'm sure that the route...
