Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,is there any clue to NAT PORTS when no nat-control is active "Enable traffic through the firewall without address translation"?thx in advanced alexxSorry I forgott, I uses a FWSM with 4.1(7). thx alexx
After I finished my configuration for my FWSM, I cannot access to the outside. what do i wrong?FWSM/pri/act(config)# pingInterface: extTarget IP address: 194.25.2.129Repeat count: [5] Datagram size: [100] Timeout in seconds: [2] Extended commands [n]...
Hello Everybody,we have some probs with our implemented FWSM. Some Clients can not connect through the firewall. I give u an example, the Subnet 10.1.4.72/29 is a normal subnet when I try to reach the router for this vpn-subnet 10.1.4.73 I got a echo...
