Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am updating my certificates on my RV320. Usually, I am doing so like that :
Build a new Debian VM (which include a fresh OpenSSL install)create a new Root CA using OpenSSL (self signed)create a new RV320 Certificate using OpenSSL and signed by ...
Hello,
I have upgraded one of my RV320-K9 V01 to 1.3.1.10 (revision including OpenVPN support).
Parameters are far from what I was expecting, I hope next release will give more options.
I would like to have a working configuration (even if it is f...
Hi,
1st, thx for your step-by-step document.
few comments :
- don't use standard openvpn TCP port. Personnnaly, I use UDP and a custom port (even if I have another router before internet).
- your admin login should be replaced by something else than ...
OVPN is generated by the router using the web interface. so you can't as the web interface didn't allow to add this option when in split mode. the only way is to set manually the dns on the client interface manually and not use FQDN.
Basically, OpenV...
Is there a way to push a DNS server and search domain from the server to the client in split tunnel mode?
push "dhcp-option DNSLAN.IP.ADDR.XXX"
but i know that some client software are not using these settings properly when in split mode.
No other rules, and that can be a problem because you can't block openvpn port (time base for example).
I didn't test the password only, but as said gk00000001 above, you have to add the root certificate to the openvpn file you downloaded.
steps are...
