Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
sorry for the seemingly dumb questions, i'm very much a newby at the whole vpn thing.. I know these RV series routers can support vpn as a server, but why can't they act as a client? What's the difference? in the end, isn't everything just exchangin...
Hello all,I'd like to buy a subscription to either NordVPN or ExpressVPN (preferably NordVPN) and, while they have their suggestions for wifi routers, I have a layer 3 switch and want to get my home behind the router. I have wifi, but that functions...
Hello everyone,I work for a small web-dev consulting firm. a couple of years ago they had a network infrastructure consultant come in and do a build-out which was a total pooch-screw.. they spent waaaay too much on equipment that was either unneces...
Hello all,I'm very very new to cisco IOS and could use assistance/enlightenment with it and how it works.In comparing the 891 (IOS 15.1) firewalling/security features to that of the small business routers, how does one go about setting up the same ba...
I've posted a couple of times but really haven't heard back.I have an SG300-20 in layer 3 mode. I have a generic, non vlan-aware gateway.I'm trying to setup a few vlans. if possible, i don't want to use VLAN1 because that's adminstrative.I've creat...
heres a bit of additional info to clear things up.the following are the firewall settings on my RV042:I haven't added any of my own access rules to the rv042, and i disabled DMZ and the 2nd WAN port because I have no use for them.it's all really sim...
Hey Mike, Thanks for the response! I'm sorry to say but I'm very very novice with cisco and while i sorta get the point of cbac and zone based firewalls, i don't know enough at the moment to get really granular with them.I have an 891 router which ...
here's that diagram i was talking about;SO, i'm not using my WAN router for anything other than a gateway.. i will create static routes on the switch.I believe it was you who told me to use 192.168.0.0 255.255.0.0 as the routing statement, but i mu...
Hey Dave!Thanks so much for getting back to me. I'll have to try what you suggested when i get home.What i'm trying to do is, as you put it, to have all off my 192.168.x.x networks contained in the switch itself.all VLANS communicate through the sw...
