About Sugam Rangan

Sugam Rangan · 08-16-2016

Hi All, I have a setup as shown below. Its a already running setup, having two ISP links terminating on 2 switches. From both switches, two links further coming out and terminating on each firewall. Both Firewalls are running in HA Mode Active and S...

Sugam Rangan · 08-18-2016

Thanks Karsten, you helped alot.

Sugam Rangan · 08-17-2016

So in case i don't have Monitoring for outside interface, fail-over will not happen because of below command? no monitor-interface outside-1

Sugam Rangan · 08-17-2016

ok, In my case its showing no monitor-interface outside-1 no monitor-interface outside-2 for the output of Sh run monitor-int

Sugam Rangan · 08-17-2016

Nops, Its showing that Interface as (Not-Monitored) while giving command sh failover because standby IP is still not configured for WAN ISPs.

Sugam Rangan · 08-17-2016

In case if i manually Disconnect the cable of ISP1 on FW 1 coming from switch, that means now FW 1 have primary WAN fail and Secondary is still available. However, Secondary firewall is still UP with both ISPs. Will failover happen in this scenario?

Member Since	‎08-16-2016 01:21 AM
Date Last Visited	‎02-07-2021 01:56 PM
Posts	21
Total Helpful Votes Received	5

User Statistics

User Activity

Cisco ASA HA - WAN Mesh

Thanks Karsten, you helped

So in case i don't have

ok, In my case its showing

Nops, Its showing that

In case if i manually