Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looks like the NAC agent customizations can be done only when the client PC pullsthe install from the CAM. Our PCs do not have admin rights and the software will be pushed through a software distribution tool. Is there any way to distribute the softw...
I am trying to get NAC integration with WLC working for wireless users in OOB and can't get it to work. I followed directions step by step from the Configuration Example on the Cisco web site. Without enabling NAC on the WLC I am able to associate an...
HiI have NAC deployed in L2 OOB VGW mode and everything works fine. We see the FWSM , which has the L3 interface for the access VLAN, bombarded by UDP port 8905 traffic. I believe this is happening even after the PCs have changed to access VLAN (as I...
Thanks for the response. Yes I am doing packet capture on switch level to find this out but it would have been helpful if CAS logged this like an ASA does especially while troubleshooting AD login slowness to see what traffic from clients are being b...
FaisalI haven't tried to browse to the CAS IP. I will try that when I am there next time. The laptop did have a NAC agent with a discovery host of the CAM IP as it was used as a wired client before. Looking at the routing table, I would think routing...
FaisalI do see the wireless client in the arp table but cannot ping it. Do I need to add a static route? The Managed subnet should suffice , right?ThanksShaffeel
I have checked that. But even before the SNMP set comes into picture shouldn't my traffic flow to the untrusted interface of the CAS and my IE page get redirected to the web login?
FaisalThanks for your response. So just to confirm, even after authentication and posture assessment is complete, the agent tries to send these packets every 5 seconds? There is no way to stop this behaviour?Shaffeel
