Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Situation: I have to recommend a switch for a client and their usage will be as follows: Switched environment needed in main building using about 32 ports, about 10 other ports are being used by satellite buildings for Internet Access and access to t...
I have set up TS running through to our TS machine via external IP x.x.x.85 and it runs fine. I have a problem with one of our users who insists on using TS to connect to his machine at home during work hours since this hole was opened up again.Is th...
Hi,our need is this: To allow access to a TS server when requests for 3389 are sent to the outside of the PIX. To direct all other traffic (VPN/Email/FTP etc) to our existing authentication server. I have updated the PIX software to allow port redire...
I am running a PIX 515 and I want to enable requests from outside the network for Terminal Services to be forwarded to one particular server. I have my main gateway which is a static IP translated to one server, but I want the requests for TS to go t...
I have a PIX 515 with 2 Interfaces and a 3600 router with 4 Interfaces.The PIX is our gateway from the router and hence the outside world to our internal switch and hence the whole internal network. I want to use one of the 3600 interfaces for a new ...
The links to other buildings are either going to be CAT5 or even Cable Internet to one site through a VPN. The total distance of the spread is about 2km, (just over a mile) for the longest distance. Some runs are about 200 metres.Gig is not needed. F...
global (outside) 3 outsideIPaddress netmask 255.255.255.255conduit permit tcp host outsideIPaddress eq 3389 anyconduit permit tcp host outsideIPaddress eq www anyFor outsideIPaddress put in the actual outside IP address. The first is to allow a globa...
You have to reinstall the OS and go back to your last backup. The start is covered well here: http://www.cisco.com/warp/public/110/34.shtmlYou do have an old backup of your PIX config I hope.Glyn
Thanks for the option, but is there any way without spending out on new hardware? The 3600 and mods is new and the boss is still reeling from that one.
