Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionPrerequisitesConfigureVerifyRelated Information Introduction On number of occasions, we have SRs opened(usally severities), wherein Customers have issues with accessing servers from outside a specific network. Usually in such scenarios,...
Hi Andy, As suggested by Chirag, we can upgrade from pre-8.3 Code directly to 8.4, its not necessary to upgrade to 8.3. All we need to take care of are the nat-changes, which is different in 8.3 and 8.4.Regards,Akhil
hi Larry,Hope the upgrade was done as per the path recommended by cisco, the upgrade path is from 7.2(x) --8.0(x)--- 8.2(x). You can verify the image using " show bootvar", and check if the image is the right one. If you have any doudts with the new...
Hi ,Since you have /30 mask between ASA and router, you will have 2 ip address from the ISP, 1 for the outside interface of ASA and 1 for the router's interface. There is no requirement that they must be assigned to any public pool as such.Hopefully ...
Hi,There is no need to add x.x.x.25 and x.x.x.80 to the outside interface.The outside interface will have the different unique IP address in the same subnet as the x.x.x.25 and x.x.x.80. These are public ip address are uniquely assigned to the privat...
