Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have MDS9509/9513 with X9124 modules with 4Gb ports.We do notice that FMS reports a fix 400MB (shareable ofcource) for an interface speed, where as the "show interface" command shows the speed of the interface as 4Gbps (which translates to 512MB)....
I am planning on increasing the bandwidth on an existing PortChannel group this coming Weekend. Although, I have done this on a couple of occasions earlier in prior versions of SANOS, but we are at a newer version of SANOS (3.3.2) now and hopefully i...
following message pops up when generating a schedule for a report. "Scheduling failed! Please set property:server.forward.email.fromAddress under admin --> preferences"Although, all information is provided and the FMS server's Perf collector is resta...
Has anybody encountered this kind of error "bitErrRTThresExceeded" for a port (connected to a server/storage)?When we bounce the port the port comes up "on" but again goes down after a while with the above error.Any ideas?
Ian,I am thinking that it uses 8 bit conversion on the CLI. From the output below the bits when divided by 8 gives the bytes as shown.Now if you further divide the bytes by 1024 it is little over 400MB (400.19MB).Unlike FMS, CLI claims the port speed...
Both of your procedures may be applied if there are two existing ISLs and you want them to be part of a new PortChannel.I followed my procedure.My intent is to add more NEW ports to an existing PortChannel and which is also as laid out in the MDSCook...
Thanks all for replying to this post.However, I have verified each one of the components SFIPs/cables/patch panels,switch port etc. Although, the error is rare but it does comes on and off on various ports at times.Do you guys think this error could ...
