Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, Is there are a way that we can set up MX firewalls in HA using the LAN IP instead of the WAN IP? The setup will be, 2 MX firewalls on different geolocations. Site 1 will be the primary active and Site 2 will be the secondary passive. Sites a...
Hi @RafaelDanelon,The Historical device data on the Access Point summary page is about the real-time connectivity status with options to preview up to last month only. I am not sure if Meraki will be adding a custom range feature for this but definit...
I'll try to configure the MX using the MX uplinks instead of the virtual uplink IPs. Unfortunately the sites were configured that way and I cannot change it as those are datacenters. It was designed as flat network so that when during business contin...
Thanks bro for this. I've already read these articles as well.Ok. So on our setup, the WAN uplinks are not in HA. Meaning, ISP1 is only for MX1 and ISP2 is only for MX2. Hence I cannot use the warm spare configuration that uses the uplinks.Yes there ...
Corp VLANs A, B, and C are also at Site 2. When the MetroE/VPLS went down, both MX will become active. But when the MetroE/VPLS went up, Site 2 MX will become passive again.
