Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey folks,I ran into an issue that I just can't figure out, and need some help. I was brought in to create a new VLAN and install some WiFi APs for guest access. Nothing new. ASA 5510. So I created the new "VLAN 60" as a sub-int on eth0/1, where they...
Here it is. And thank you for helping me with this. I really appreciate it!lstc-3560-core#sh runBuilding configuration... Current configuration : 3351 bytes!version 12.2no service padservice timestamps debug uptimeservice timestamps log uptime!hostn...
Another little oddity is that I can't ping the interface addresses from the opposing network. So from VLAN 60, I can't ping 10.10.5.1. And from VLAN 5 I can't ping 10.10.60.1. Devices on VLAN 5 are being given a gateway of 10.10.5.11, which is a L3 s...
The end goal is to have it work with DNS, but for now I'm just using a port scanner to the IP of 10.10.5.19 and all ports come up with a no-reply.I changed one of the DNS servers on the DHCP scope to an internal one, 10.10.5.24.Set up the capture, op...
Sorry it took so long to get back. Here's the output. Maybe I'm blind, but it looks like each phase is allowed. Phase: 1Type: ACCESS-LISTSubtype: Result: ALLOWConfig:Implicit RuleAdditional Information:MAC Access listPhase: 2Type: FLOW-LOOKUPSubtype:...