Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using an ASA 5510 for both remote access and site to site VPN. Is there a way for the remote access clients to access the remote sites via the site to site tunnels? I have included the IP address range of the remote access clients in the crypt...
The pool of addresses for remote access is 172.25.25.1 to 172.25.25.254. This is the address pool referred to by RemoteAccPool. I have confirmed that this range of addresses is in the ACLs on both ends of the tunnel. This is were I first started l...
The ACLs appear to be working fine. I am passing IP traffic for all of the configured subnets with the exception of the remote access subnet. I have both ends of the tunnel configured with the RA subnet in the crypto map. I am not using reverse ro...
