Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 515e running 7.0(1) and one problem with the config of my NATs on my PIX is that the inside interface is not NATed. Rather just the subnet of my internal network. So when I try to add a NAT rule for a single host on that subnet I get: ...
I have a Cisco 515e running 7.0(1) and would like to allow a single public IP to translate traffic to different internal hosts on my network by what port they are trying to access on the outside. So for instance if someone entered X.X.X.X:85, the pi...
I have a PIX 515E w/ 7.0. We have a Wireless network that is associated with its own interface. We have 3 interfaces: INET, LAN and WIRELESS. There are no DNS servers on this network and clients perform DNS lookups to the Internet provider's serve...
One problem with the config of my NATs on my PIX is that the inside interface is not NATed. Rather just the subnet of my internal network. When I add a NAT rule of the above I get: "This static port mapping rule is overlapping with a dynamic addres...
