Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have to enable SSH and HTTPS in a CISCO ASA 5505. SSH and HTTPS must accept request only fron certain addresses of the WAN.How can I do it?Thanks in advance,Simone Spagna
the address of the ASA is on a private network (I wrote 10.10.10.10), so is not reachable from the Internet.On the private address is routed by the provider a public subnet (I wrote 89.100.100.64/28).If I configure the ASA, I can route the subnet on ...
I didn't set up contexts and I prefer not to, if it's not stritly required (by the way, I tried to list contexts, but I got an error - command not found - is ASA 5505 capable of managing contexts?).The problem with your answer is to know what are the...
The complete situation is: My ASA is on a private network, say 10.10.10.0/24. Trough the ASA IP (say 10.10.10.10) is routed a public network (say 89.100.100.64/28).The internal network is natted as 192.168.0.0/24.I'm able to static nat some public ip...
