Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all: i meet a problem is that all my lightweight ap join the controller with AP-Manager IP but i pretty sure the DNS a record is point to the management ip of controller ,not the AP-Manager IP.The log show as below :*Aug 11 19:11:12.470: %CAPWAP-...
Hi All: My WLC already firmware already update to latest version 6.0 and the management ip and ap manager ip in the same subnet, DNS record already have the CISCO-LWAPP-CONTROLLER and CISCO-CAPWAP-CONTROLLER A record.But Some lightweight AP cannot ...
Hi all : We user WISM ver.5.0.148.2 , All AP is 1230 Series and Use Windows 2003 DHCP server.All AP cannot get IP after upgraded Lightweight from Autonomous IOS.But I found the DHCP is work if i use my notebook connect the same switch port and my no...
Hi all: I just set up 10 vlan interface and 10 AP groups for each vlan by only One SSID.But it's didn't work for me.All the client cannot get IP and even prompt a wep key enter . I set up something as below :1.set up AP group and assign vlan interfac...
Hi all: I had add a hostname to DNS server as CISCO-LWAPP-CONTROLLER . and i use my controller as a internal DHCP server , it will assign ip to a lot of vlan. My lightweigh ap cannot translate the cisco-lwapp-controller and other a record at DNS ser...
hi fella5 : As i have 100 more Lightweight AP , Any method i can make ap join wcl without console ? i console to one AP and i can see the ap ip address , gateway , controller ip is correct and controller ip point to controller management ip address...
Hi dancampb : Many thx for your message , i am clearly now. But My controller still close the AP join request by the error log as below :*Aug 11 20:01:01.289: Join resp: Unable to encode CAPWAP Control IPV4 Address*Aug 11 20:01:01.289: 00:21:d8:44:...
hi fella5: yes , it's done , the WLC already have the SSC Code and i verify the SCC code is correctly. the Switchport configured that vlan 99 access port and the Global Vlan ID set the IP helper to the DHCP already.I can ping to the DHCP , DNS and ...
