Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco ASA5510 and a server that has Intel PROSet for Wired Connections loaded in an Adaptive Load Balancing mode. When i place this server behind the firewall, everything works fine. However, when I place a rule in the Access-List and a St...
I'm new to the world of cisco. (asa 5510). I have a rack at a data center that has multiple IP addresses - 254.16.220.1 thru 254.16.220.62 (obviously not the acutal addresses.) I need to integrate it slowly into my rack, pulling one server behind it ...
I'm new to the world of cisco. (asa 5510).I have a rack at a data center that has multiple IP addresses - 254.16.220.1 thru 254.16.220.62 (obviously not the acutal addresses.)I need to integrate it slowly into my rack, pulling one server behind it a...
I have mased my external IPs for obvious reasons.As i stated - the current machines, which only have 1 nic, work fine. when i attempt to pull a server that has dual - nics using Adaptive Load Balancing by Intel, and i add a mapping in (for RDP), the...
That is what i was afraid of.Here's my scenario:I have my ethernet coming into my rack that is presently hooked into my switch. So the traffic comes into my dell powerconnect 2724 switch, then goes directly to the boxes from there. all of my server...
