Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Orginal plan is one uses DYnamic IP and the other uses Statice, but since the dynamic is not working I tried to configure static on both ends but it still will not come up.Stuck on Pahse 1 - I have used PIX and set them up without any problem.Here ar...
There are two phases. Phase 1 was using AES and Phase 2 is using 3DES. As long as both sides of the tunnel match Phase1 in this case AES and Phase2 which is 3DES then the tunnel will come up.
Actually that is not the issue, the issue was a limitation which only allows 10 inside host to connect. The way around this was to acl the inside interface to permit only essential traffic from specific clients/Servers.
#####################################Here is a part of the debug: REMOTE B#####################################Aug 18 07:18:25 [IKEv1 DEBUG]: IP = REMOTEIP, IKE MM Responder FSM error history (struct &0x351ecd8) , : MM_DONE, EV_ERROR-->MM_WAIT_MSG3...
