Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, I have installed Embedded Wireless on catalyst 9300 switch, now I am trying to register the Access point (Model numbers : 3702 and 1852i) but I am unable to do the same as it is registering for a minute and trying to download the EWLC...
Hello Everyone, I am trying to integrate the Embedded WLC with Catalyst 9300 switch but i am unable to do the same.I tried to upgrade the switch with 16.10.1 IOS version and I also upgraded the switch with 16.10.1 Wireless package as well but I am g...
I have enabled the same command in switch by still Netconf is showing as Failure in GUI. I have also upgraded my switch and WLC package to 16.11.01.c version. Below are the commands which is already present in switch: aaa new-modelaaa authorization e...
I have tried the same but its not working and also one thing to highlight here that Netconf is showing as Failure in Cisco DNAC GUI but however we are able to login to netconf through maglev with port number 830.
This is a SDA network and we have already installed the 9800 Wireless package on cat 9300 switch. We too have DNA advantage license available in cat9k.
The running version on cat9k is 16.10.1e and we have installed the below WLC package as well. Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 64 C9300-48U 16.10.1e CAT9K_IOSXE INSTALL Active PKG Information...
