Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,I have Ace 4710 version A5(1.2). When I'm logged on to the GUI, I see the Admin Context is in sync but the user Context are not in sync. When pushing the button "CLI Sync" or "CLI Sync All" I see the following error message: "Device discovery fail...
Hi,I have a ping issue too. I am not able to ping the interface IP in a context. After reload the ACE the ping is running for a week. When updating version A5(2.1) the issue was fixed.I suppose a bug in Version A5(1.2)Regardsamb
Hi Raman,SSL SessionID stickiness is not a good idea, because SSL SessionID is not constant:https://supportforums.cisco.com/message/459511#459511If there is no other way, don't forget:parameter-map type generic SESSID-PARAMset max-parse-length 76stic...
Hi Patrik,to monitor the ACE I use these two MIB's:ftp://ftp.cisco.com/pub/mibs/v2/CISCO-SLB-MIB.myftp://ftp.cisco.com/pub/mibs/v2/CISCO-ENHANCED-SLB-MIB.myExample for CPU:cpmCPUTotalEntry 1.3.6.1.4.1.9.9.109.1.1.1.1The resource usage and other inter...
Hi Pawan,the network behind the ACE (172.16.1.0/24) must be known by the router in front of the ACE. You must have a static route on the router (L3-switch) pointing to the alias address of the ACE. To reach that network from the hole LAN you must red...
