Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm looking for a way to configure a specific Circuit Vlan #'s Ip Address as source ip address of log messages sent as result of the "logging sendmail" command. (at the moment Sw Version: 7.30).Does anyone know a way get it ?Thanx in advance !Fra...
Hi, as steated on the following cco linkhttp://www.cisco.com/en/US/tech/tk436/tk832/technologies_configuration_example09186a0080231a3e.shtmlit is possibile to have oute Leaking Between Different VRFs on the same PE.As i tested in on some different co...
Hi, I'm looking for detailed info on how much memory is required for a single VRF-Route (at least) in the BGP table. As far as in some sit.ns you must configure different RDs for different PEs of the same VRF (redundancy needs with RR involved) this ...
Hi,does anybody know something about the degree of implementation of RFC 3270 (Multi-Protocol Label Switching (MPLS) Support of Differentiated Services), particularly on the classification based on Labels (L-LSP)?From what is detailed on the CCO it ...
Hi Pete, I've tested and implemented your suggestions with the expected results !Thanx so much for your patience and great support!hope to hear from you again.regardsFrancesco
Hi Petethanx so much for your reply !I'm going to test it asap, but in the meanwhile I have another question (regardind the "logging sendmail" command as well): when I receive an e-mail message sent by the CSS, the Subject Field is "0.0.0.0" and cons...
Hi thanx for your reports, really interesting !If I ever could test anything similar I'll let you know for sure!Hope to hear from you soonCheersFrancesco
Hi, i could test the proposed workaround (Cisco7609, IOS version is 12.2(18)SXD3, Sup720-3BXL, NO OSM):***********************************ip access-list extended test permit tcp any anyRoute-map test permit 10 Match ip address test set ip precedence ...
Michael,I hope to test that workaround (and possibly its impact ) in thr next future.Anyway with 720-3bxl and 12.2(18)sdx (no osm) a policy map (matching any and marking ip-dscp to, say, cs1) desn't work if traffic enters the 7600 as IP and leaves as...
