Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to setup a port forwarding from outside to my Camera but it is not working. I do not have static IP address.
Could please someone look and advise where I am going wrong? I have tried to change the Nat statement to
object network Cam...
Nat Rule not working | Firewalling | Cisco Support Community
Hi,
I am newbie and learning to manage the ASA 5505.
I have got a site where we have one broadband with one Static IP.
I wanted to config...
Can please someone advise? The problem I could see that I have got only one IP address and the camera is on the other subnet rather than ASA's own subnet and I can not get the Nat to work.
I am sure someone has got the answer for my problem.
is it something to do with same subnet. as CCTV is on another subnet.
When I use sh arp command I do not see CCTV subnet and my layer 3 switch does the routing for Vlans.
I think it is more of a routing issue here but trying to understand where I need to start as One is working but the second one isn't. The VLANs are same and nameif interfaces are same as well. Both ASAs are on the same subnet.
I just tested a NAT on ...
Let me explain my setup. I have got two asa and the old asa 1 is working ok and I have got static IP addresses for each service. I have added a second switch and ASA2 for resiliency. All the internal traffic goes to ASA1 and NAT is fine as the switch...
