Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
Problem:
I got the following error message when I try to access IPS using CISCO ASDM 7.1(3):
Error connecting to sensor. Error Loading Sensor
I have tried solutions suggested by other discussions with no success.
I am using Java Runtime 6.
W...
I figured out what the problem is. The default IP of the IPS was configured to be the same as another node on the network. I have corrected that issue and am now able to connect to the IPS. Thanks a lot for the help !
As for you question. We are usi...
The IPS is in a non-production setting. And I have re-imaged it using the following command:
sw-module module ips recover configure image disk0:IPS-SSP_5515-K9-sys-1.1-a-7.1-8p1-E4.aip
sw-module module ips recover boot
But after boot up th...
Yes I have, when I run the above command, here is the output:
Card Type: ASA 5515-X IPS Security Services Processor
Model: ASA5515-IPS
Hardware version: N/A
Serial Number: FCH18177HZB
Firmware version: N/A
Software vers...
