Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Check that you have enabled some sort of stickyness. ex "advanced-balance sticky-srcip"If you are using "balance roundrobin" (and some others) the individual requests for page objects will hit different servers, and if the content on the servers is n...
Yes - There are several ways of doing it, but the one that cisco intended for such situation, would be using a VIP range (if the addresses are consecutive).Ex : vip address 192.168.1.1 range 2If the addresses are not x and x+1 (or x and x-1) you woul...
This solution uses redundancy, this is fairly slow (convergence in case of a fault is above 20 sec).I would suggest that you try and use virtual routers (convergence time is less that 2 sec, except if the fault occured because of a layer 2 event, the...
When you upgrade/downgrade to a version you have previously run, the CSS will restore the config you had when you ran that version the last time.I haven't bothered to check the docs or figure out myself, how to disable this behavior. I just get a cop...
