Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anybody say definitely whether a single CiscoWorks 2000 server will support a mingling of SSH-enabled and non-SSH devices? I mined CCO Search and 9 months of this forum but I can't locate that answer.
I've been struggling with some of our 6509 Catalysts in regard to this same issue. We converted our switch block 6509s from CatOS (with logically separate msfc routers) to IOS (where the msfc router configurations merge with the switch configuration)...
Any TACACS-secured router with, example set up below, would enable subnet 10.1.1.0/24 as the only addresses permitted to telnet in. Then syslog and TACACS logs could chronicle good and bad attempts. access-list 110 permit tcp 10.1.1.0 0.0.0.255 host ...
I recently took a fairly comprehensive CiscoWorks 2000 administration class from http://www.knowledgenet.com. It was called "Implementing CiscoWorks for Enterprise LAN/WAN Management (CWENT) 1.0". I got a lot out of it, and never had to leave the off...
I would add that you should uninstall any other Java run time/plug ins prior to installing Java v1.3.1 (automatically installed by accessing your CiscoWorks server if no Java client exists.) Multiple versions can conflict with each other.
