Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I hope I can get some help with my configuration of my ASA.
The current situation:
5 Public IP addresses.
2 Servers that needs to connect to the internet.
Server1 is already connect to the internet at the 2nd Public IP.
Server2 needs ...
Hi Marius,
nat (inside_vlan253,outside) source static Server2 interface service TCP_5001 TCP_5001
and
object service TCP_5001 service tcp source eq 5001
Did the trick
I was working with the service object:
object service 5001 service tcp so...
HI Marius,
The config you show me is a config from the DMZ zone.
That was already working
I was looking for a solution to get the port 5001 & 2222 to the inside IP 192.168.253.2 working.
That has to link to the 1st Public IP address. (is also the o...
Hi Marius,
It is the full configuration. I did only an cleanup for security,
What do you mean with "Please try moving the NAT statements to manual NAT section."?
I did a clean up of the config.
So we can start from scratch.
Can you guide me stap by...
Hello Marius,
Thank for your time
Hereby the results
Phase: 1Type: ROUTE-LOOKUPSubtype: Resolve Egress InterfaceResult: ALLOWConfig:Additional Information:found next-hop "1st Public IP" using egress ifc identity
Phase: 2Type: NATSubtype: per-ses...
