Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I tried upgrading the ASA 5506-x Firepower module from 5.4.1 to 6.0.1 and uploaded the wrong boot image.
I uploaded ftd-boot-9.6.2.0.lfbff to the 5506-x and booted with that image. Now I am stuck in the Cisco FTD image. My ASA software 9.2.1/9.2....
Hello,
I recently discovered an older tool to assist in blocking malicious IP addresses. It seems the tool is no longer available. I was looking for a similar tool. I tried to download it, but to no avail. The open source tool is called blocklist2ac...
Hi,
I got my 5506-x up and running and need to apply the license to the fpower module.
My device came with a big white envelope and contains a software serial number sticker on the front of it, and the contents inside the envelope contain (1) piece o...
Can someone please explain why I see two different time stamps in my MARS Raw Logs below for incidents.Here is a copy of one of our raw logs. I changed some info.8816265728ÿ05/07/2013 17:00:01ÿfirewallASA1ÿ0.0.0.0ÿ64823ÿ10.*.*.*ÿ636ÿ6ÿ<156>May 07 201...
Hello:What would be the best rule to use to determine whether or not a device (including routers and switches) is up and able to report/log?Thanks in Advance.
I think you are right. I do have TrendMicro installed on the laptop. I'm going to have to kill all those TrendMicro processes and try again. I have limited time during the week, so I will try this again on Saturday.
It timed out. I think connectivity was the issue as you stated.
I used the console cable to run the rommon commands, then, plugged in cat5 cable from my laptop to the Management port 1/1 on the 5506-X, which is the port right above the console port....
kaisero, thanks. I followed the guide and ran into some issues.
I did an erase disk0: and wiped it, then tried to load the following file.
It seems the ASA was trying to pull the file off the TFTP but wouldn't transfer the file. I was trying to tft...
Newbie error. Can someone assist with instructions on getting the ASA 9.*.* image back on this 5506-x? The device doesn't fully boot up, and the orange light stays lit on the device. When I console into the 5506-x its the Cisco FTD login prompt. I c...
