About neilkolar

neilkolar · 11-06-2015

I am using the recovery menu system built into the appliance. I haven't received the error that you ...

neilkolar · 11-06-2015

I am trying to reimage an 8350 appliance. I have been following the guide located here: http://www.c...

neilkolar · 02-26-2014

Nothing yet and I had to leave that customers site. Out of curiosity, are your 3850's strictly switc...

neilkolar · 02-18-2014

After the AP is online and associated to the 5760 is when the Input and CRC errors start happening. ...

neilkolar · 02-18-2014

Cable is swapped. Counters are cleared. Here is the latest output.SWITCH OUTPUT#sho int g2/0/38Gigab...

neilkolar · 02-18-2014

Instead of taking down an existing one, I got a different one and hooked it up directly to the switc...

neilkolar · 02-18-2014

Thanks again for the help Leo. Here is the latest from g2/0/24. I haven't reset the counters on this...

neilkolar · 02-18-2014

I just verified it happens without the module as well.

neilkolar · 02-17-2014

Here is another output if this will help. The highest error ports are the ones with AP's connected.C...

neilkolar · 02-17-2014

I tried that and they still do. I took the AP that was connected on int G4/0/44 and connected it dir...

neilkolar · 02-17-2014

Just noticed the obvious correlation here. The "133657 1519 to 2047 byte frames" is the same count a...

neilkolar · 02-17-2014

Leo,Thank you for the reply. I initially thought it was cabling too but it is only happening on the ...

neilkolar · 02-17-2014

I have a client with 3602i AP's with the AC module on 3850 switches. They are seeing Input Errors an...

I am using the recovery menu