About g.sprietsma

g.sprietsma · 10-30-2006

i have the following question. I want to exclude the san from the performance issue so i checked the interface errors en discards but no errors and discards found(or few). Further i checked in Device Manager the FC Enabled ports with the monitor opti...

g.sprietsma · 07-11-2007

inline module is necessary

g.sprietsma · 11-01-2006

what do you mean with frames are lost. in my opinion out of bbcredit means that the buffer is full because the frames can be switched for some reason (long distance). where do you mean the frames are lost ?

g.sprietsma · 10-31-2006

is receiving corrupt frames the only way the switch can be out of bbcredits. is it wise to adjust the bbcredits ?another question: are there other counters we should watch to see if anything goes wrong. because no errors and discards on the interface...

g.sprietsma · 10-31-2006

thanxs for your reply. i will check if they are of the past or that they grow during time (which means the problem is still going on)can i reset the counters ? I trieded it with clear counters interface all which didn't reset this counters.i can use ...

g.sprietsma · 10-31-2006

Thank you for your replyI also don't see any errors and discards on the interfaces. But i see some errors under Device Manager and then Interface -> Monitor -> FC Enabled ..Under Link errors i see a lot of TXInvalidWordsUnder Protocol i see a lot of ...

Member Since	‎05-10-2006 02:49 AM
Date Last Visited	‎11-05-2023 01:13 AM
Posts	6
Total Helpful Votes Received	5

User Statistics

User Activity

performance problem with mds9216i SAN

Re: WAAS inline without module?

Re: performance problem with mds9216i SAN

Re: performance problem with mds9216i SAN

Re: performance problem with mds9216i SAN

Re: performance problem with mds9216i SAN