Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to download both 8.4(6) and 9.5(2) to this Cisco 5585X. I downloaded the bin for 8.4(6) just fine. However, I have not yet upgraded the code from the existing 8.2(5). I wanted to get both codes on the firewall, because I need to pull it off...
Hoping someone can help me here. I have a dynamic nat pool set up to translate on the inside about 200 IPs to 20. I have 10 ACLs, where the inside hosts/networks can connect to multiple hosts over multiple protocols/ports. The inside users have to...
Hi. I have the following scenario and not sure how to build a NAT for it. Using OS 8.3(2) ASA 5510 secplus licI have a device on Outside interface that ONLY can talk to devices on its own broadcast domain, but I have a device on the Inside interfa...
it boots, then crashes and tells me upon the next boot the crashdump info will be available. problem is it just boots and crashes, boots and crashes.. I have a TAC case open for it 680382857. I'm stuck.. I have it sitting in rommon right now.
I upgraded to 846... all good. there are some errors I have to address that did not translate. but when I then went to upgrade to 952.. crash. I tried to boot to 846 from rommon, but still crashed. trying to drop back to 825 again now. I did a v...
correct. I'm just trying to get 9.5.2 onto the firewall, so when I pull it off the network (the backup) to reconfigure it, I have everything already on it. It wouldn't pose as big of an issue, but I'm in the USA, and the firewall is in Italy.
I wa...
Thanks Sergio. Do you know if this is new to 9.5? I'm almost certain I've downloaded 8.4 and 9.1 at the same time. Then upgraded the code to 8.4 then to 9.1. But it was a while ago, so I may have forgotten.
I have a Dynamic NAT and doing a twice NAT. The connection works initially when the inside host makes a connection to the outside host over TCP/259 (this is to authenticate to a Checkpoint firewall). Translation on the inside (192.168.1.1). Then w...
