Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried to use the CLI to create the cert request..I’m getting a DME error fromScope security..Then the log message pops up about the DME..so something is wrong with this build related to the cert..
Ivan
I had the same problem. Perform the following:
Step 1 UCS-A# scope security
Step 2 UCS-A /security # scope keyring default
Step 3 UCS-A /security/keyring # set regenerate yes
Step 4 UCS-A /security/keyring # commit-buffer
I was able to us...
Assuming you are using VMW Workstation, you need to configure workstation so it provides a dhcp address to the emulator, via the console in workstation, you can see the ip UCSPE aquires.use a recommened browser to connect to the ip seen in the consol...
