Hello Cisco People. I am using my Cisco RV220W as primary gateway/router on my LAN but has recently added a secondary gateway/router (4G Mobile Broadband Router). Is it somehow possible, via RV220W static routing, to route all traffic for a specific client on the LAN, say 192.168.1.100 to always access the internet via the secondary router ? It is only one specific client which should always route via the secondary router, all the rest of the clients on the LAN should use the primary router. Facts: Primary Gateway/Router (DHCP Server): 192.168.1.1 Secondary Gateway/Router (NO DHCP Server): 192.168.11.1 Subnet Both: 255.255.255.0 RV220W IPV4 Routing Table (Default): Kernel IP routing table Destination Gateway Genmask Metric Ref Use Interface Type Flags 127.0.0.1 127.0.0.1 255.255.255.255 1 0 0 lo Static UP,Gateway,Host 192.168.1.0 0.0.0.0 255.255.255.0 0 0 0 bdg1 Dynamic UP 192.168.1.0 192.168.1.1 255.255.255.0 1 0 0 bdg1 Dynamic UP,Gateway 192.168.11.0 0.0.0.0 255.255.255.0 0 0 0 eth1 Static UP 192.168.11.0 192.168.11.142 255.255.255.0 1 0 0 eth1 Static UP,Gateway 0.0.0.0 192.168.11.1 0.0.0.0 0 0 0 eth1 Dynamic UP,Gateway I am kinda noobish on this Iptables thing, used to GUI - but GUI can not help me this time, hope a friendly sould out there could help me instead. Any help is appreciated, Many Thanks ! Martin B.
... View more