You won't be able to export the config directly from the pix running 6.3.4 to the asa running 8.2.1. You would need to upgrade your pix from 6.3.4 to the 7.2 code. You can follow the procedure below. Please be aware of the memory requirements. h...
Hi Amy,What version of code are you running on the CSC module? There are some software issues that could cause this. CSCtg06921 , and CSCtc37947 are possible causes of this issue. If you are not running the latest patch 6.3.1172.3, I would suggest...
Hello,The show mac-address-table command will only work in the Transparent firewall.You can take a look at the command reference here. You will notice the bullet is only under transparent.http://www.cisco.com/en/US/docs/security/asa/asa80/command/ref...
Hello Jerome,I suspect the issue is between the ASA Eth0/1.1 and your Switch Fa0/1 trunk. On the switch, usually by default vlan 1 is the native vlan and this vlan is not tagged on the switch side. However, your traffic on the ASA side will be tagg...
Hi Paul,I would check to to see what vlan the SSM management port is connected to on the switch side. If a local device in the same subnet as the SSM is not seeing the arp then it could be a vlan issue. Perhaps the SSM is not in the correct vlan. ...