Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have two ports I want communication between and I feel like it should work but still even pings fail. Below are the relevant entries from the running config. Any idea what I'm missing? Thanks. P.S. (1) Because wouldn't let me post otherwise....
Hello, I have two ports I want communication between and I feel like it should work but still even pings fail. Below are the relevant entries from the running config. Any idea what I'm missing? Thanks.interface GigabitEthernet0 mac-address 020c.f142....
Hi, thanks for your help. I'll be sure to rate your posts after the problem is identified of course. So this is the config I have now:interface GigabitEthernet0 nameif left security-level 0 ip address 192.168.0.1 255.255.255.0 !interface GigabitEther...
Oh ok, yeah I'll get back to you tomorrow morning with the results of your suggestions since I'm not at work at the moment. Thanks. I guess I was worried that perhaps the ASA unit defaulted to highly restrictive ACLs when none were otherwise present,...
Hm yeah I thought I'd be able to ping too. But I ruled out iptables because a machine on one subnet can't even ping the gateway of the other subnet. As for the ACL, I thought that had to be done to allow ICMP traffic to come in and out both sides? Or...
